Deleting An Individual Switching; Point; Resetting An Entire Program (Overwriting With Factory Settings) - Bosch FR 120 Installation And Operating Instructions Manual

B Turn until the required operating mode
(e.g. Economy) or temperature is shown.
The segment ring always shows the effect of
the change on the heating program.
6
B Press .
The operating mode is saved. Setting of P1 is
now complete.
B You can now:
– change more switching times and
operating modes in the same way, or
– finish programming and return to the
standard display by pressing
Using groups of days when programming
In many cases, you may want to programme the
same switching times for several days of the
week, say for all working days. Equally, you may
also want a different program for just one of
those days.
Using the groups of days when programming
enables you to complete the process in only a few
steps.
B For a group of days, e.g. Mon - Fri, programme
the switching times and operating modes that
should apply to the majority of the days in this
group of days.
B Then change the switching times for the days
that are different.
9 12 15
h
3 24 21
h
6 720 800 817-08.1O
.
menu
5.3.2 Deleting an individual switching point
B Place the highlight onto the value to be
deleted, as described in chapter , e.g.
parameter P1 (= switching point 1).
B Press .
The switching time and the associated
segment inside the segmented ring flashes.
18
B Press .
The deleted switching point flashes. At the
same time, the associated segments change.
B Press
B Deleting P1 is now complete.
5.3.3 Resetting an entire program (overwriting
with factory settings)
B Call up menu: Heating > Programme,
Domestic hot water > DHW programme or
Domestic hot water > DHW circ pump prog .
B Turn until menu point is highlighted.
B Press .
No flashes.
B Turn until Yes flashes.
B Press .
The program was reset to its standard setting.
Operation | 23
9 12
h
6
3 24
h
9 12
h
6
3 24
h
twice.
6 720 800 817 (2012/02)
15
18
21
6 720 800 817-06.1O
15
18
21
6 720 800 817-09.1O