Zur Luhne 2 The term “power tool” in the warnings refers to your mains- 37589 Kalefeld – Willershausen operated (corded) power tool or battery-operated (cordless) Unter www.bosch-pt.com können Sie online Ersatzteile be- power tool. stellen oder Reparaturen anmelden. Kundendienst: Tel.: (0711) 40040480...
Page 7
If ute. Damaged accessories will normally break apart during damaged, have the power tool repaired before use. this test time. Many accidents are caused by poorly maintained power tools. Bosch Power Tools 2 609 006 763 | (17.1.13)
Page 8
Kickback is the result of power tool misuse and/or incor- possibility of kickback or wheel breakage. rect operating procedures or conditions and can be avoid- ed by taking proper precautions as given below. 2 609 006 763 | (17.1.13) Bosch Power Tools...
15 Round nut* power failure or when the mains plug is pulled. This pre- 16 Cup brush* vents uncontrolled restarting. Bosch Power Tools 2 609 006 763 | (17.1.13)
*Accessories shown or described are not part of the standard de- livery scope of the product. A complete overview of accessories 19 Handle (insulated gripping surface) can be found in our accessories program. Noise/Vibration Information Measured sound values PWS ... 680-115 7-115 700-115 7000 700-125 determined according to 3 603 ...
Adjust the position of the protec- tion guard 6 to the requirements Robert Bosch GmbH, Power Tools Division of the work process. For this, press the release lever 1 up- D-70745 Leinfelden-Echterdingen ward and turn the protection guard 6 to the required position.
Page 13
Observe the instructions under “Mounting the Protective De- vices”. The protection guard may only be turned while actuat- Screw on the round nut 15 and tighten with the two-pin span- ing the release lever 1. ner. Bosch Power Tools 2 609 006 763 | (17.1.13)
Clamp the workpiece if it does not remain stationary from Bosch. due to its own weight. Do not strain the machine so heavily that it comes to a standstill. 2 609 006 763 | (17.1.13) Bosch Power Tools...
If the replacement of the supply cord is necessary, this has to Gauteng – BSC Service Centre be done by Bosch or an authorized Bosch service agent in or- 35 Roper Street, New Centre der to avoid a safety hazard.