Advertisement
PROBLEM: A green LED was illuminated before disconnecting the power from the charger, but upon reconnection,
red LEDs appear and remain on.
This is the normal operating procedure for the system. It indicates that a reanalysis of the battery status was initiated and
after a series of steps the green LED will illuminate.
LIGHT EMITTING DIODES (LED) FAULT CODE INDICATIONS
The microprocessor is constantly monitoring the charger circuitry and will both detect and display blinking LED indications if a
fault is detected. The battery type LED will be OFF during a fault code condition.
30% RED LED BLINKING ..................................................................NO BATTERY DETECTED
This indication occurs whenever the charger circuitry cannot detect a battery. The charger circuitry will not allow charge current to flow under this condition.
With the AC power supply cord unplugged, check the connection to the batteries for proper polarity (black wire to negative or -). Also check for corrosion
free secure connections to the battery.
30 & 60% RED LEDS BLINKING ............................FORMING STAGE TIMEOUT SHUTDOWN
This indication occurs if the battery voltage has not risen above 1.75 volts per cell within the first 3 hours of charging. This indicates that a possible battery
problem exists and that the charge cycle has been terminated at this point.
30, 60 & 90% RED LEDS BLINKING............................................OVERALL TIMER SHUTDOWN
This indication occurs if the charger has not completed the charge cycle within the allowable factory set time period. This indicates that a possible battery
problem exists and that the charge cycle has been terminated at this point.
30 & 90% RED LEDS BLINKING ......................................INTERNAL OVERTEMP SHUTDOWN
This indication occurs if the charger circuitry has detected operating temperatures inside the charger enclosure that are above factory specified levels. This
could indicate that a possible charger problem exists and that the charge cycle has been terminated.
30% RED & 100% GREEN LEDS BLINKING .................................. BULK STAGE SHUTDOWN
This indication occurs if the battery voltage does not rise properly during the Bulk Stage. This indicates that a possible battery problem exists and that the
charge cycle has been terminated at this point. Please call technical support for further assistance (800.742.2740).
30% RED & 100% GREEN LEDS ALTERNATE BLINKING ON OFF..........................DELTAVIEW SIGNAL OR NO BATTERY DETECTED
This will be the NORMAL indication when the charger is plugged into A/C but not connected to a battery pack, allowing the DeltaView signal to be retrieved
with a DeltaView Reader. This can also be considered the NO BATTERY DETECTED fault code. Please call technical support for further assistance
(800.742.2740).
Note: Disconnecting and reconnecting the AC power supply cord will reset the charger.
LIMITED WARRANTY
Pro Charging Systems, LLC (PCS) makes this Limited Warranty only to the original retail purchaser.
PCS warrants this battery charger for three years (unless the charger is used in a Restricted Market) from the date of retail
purchase against defective materials and/or workmanship. Restricted markets include markets outside of the USA, Rental
applications and Heavy Industrial applications. Sometimes RM is designated in the PCS Part number when ordered, but is
not part of the model number. Chargers used in Restricted Markets will have a warranty period of 18 months from the date of
retail purchase against defective materials and/or workmanship. CR refers to "Certified Reconditioned" and designates a 1
year warranty.
If such defects should occur, this unit will either be repaired or replaced at the discretion of the manufacturer. It is the
responsibility of the original purchaser to return the charger along with proof of purchase, transportation, and/or any mailing
or handling charges prepaid to the manufacturer or its authorized representative. Chargers that are purchased more than
two years beyond the date of production will automatically have a warranty start date that will be the two year anniversary of
the production date.
This limited warranty is void if the product is misused, improperly maintained, handled carelessly or incorrectly operated.
Additionally, this warranty is void if the charger is disassembled, the charger's charge cables are cut, the power cord is cut
off, the charger is altered without authorization from PCS, the serial number is removed, or repair is attempted by anyone
other than an authorized representative. PCS makes no other warranty other than this limited warranty and expressly
excludes any implied warranty, including warranty for any incidental or consequential damages. This is the only expressed
limited three year warranty authorized by PCS and does not authorize anyone to assume or make any other obligation
towards the product other than this three year Limited Warranty. Some states do not allow limitation of incidental or
consequential damages.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Please call
Pro Charging Systems, LLC for full warranty information and/or service please call (800.742.2740).
7
Advertisement
