Disk Drive - Toshiba X200 Series User Manual

Problem
Cannot write correctly.

Disk drive

For information on disk care refer to Chapter 4,
Problem
Some programs run
correctly, but others do
not.
You cannot access the
disk drive.
Real Time Clock
Problem
The following message
is displayed on the LCD:
RTC battery is
low or CMOS
checksum is
inconsistent.
Press [F2] key
to set
Date/Time.
User's Manual
Procedure
If you have trouble writing, make sure you are
observing the following precautions:
■
Use only media recommended by TOSHIBA.
■
Do not use the mouse or keyboard during
writing.
■
Use only the software supplied with the
computer for recording.
■
Do not run or start other software during
writing.
■
Do not jar the computer during writing.
■
Do not connect/ disconnect external devices
or install/remove internal cards during writing.
If problems persist, contact your dealer.
Procedure
The software or hardware configuration may be
causing a problem. Make sure the hardware
configuration match's your software's needs.
Try another disk. If you can access this disk, the
original disk (not the disk drive) is problem.
If problems persist, contact your dealer.
Procedure
The RTC battery charge has become exhausted,
you should set the date and time in within the
BIOS setup screen through the following steps:
1. Press [F1] key. BIOS setup will boot up.
2. Press [F2] to set the date in [System Date].
3. Press [F2] to set the time in [System Time].
Troubleshooting
Operating Basics.
10-16