Toshiba X200 Series User Manual page 171

Problem
After making a call you
can't hear a ring.
Communication is cut
off unexpectedly.
A CONNECT
quickly replaced by
CARRIER
Character display
becomes garbled during
a communication.
You cannot receive an
incoming call.
DVD Super Multi drive supporting double layer disc recording
For more information, refer to Chapter 5,
Problem
You cannot access a
disc in the drive.
User's Manual
Procedure
Make sure the tone or pulse selection in your
communications application is set correctly.
The computer will automatically cut off
communication when connection with the carrier
is not successful for a set time interval. Try
lengthening this time interval.
display is Check the error control setting in your
NO communications application.
.
In data transmission, make sure the parity bit and
stop bit settings correspond with those of the
remote computer.
Check the flow control and communication
protocol.
Check the "rings before auto answer" setting in
your communications application.
If problems persist, contact your dealer.
Procedure
Make sure the drive's drawer is securely closed.
Press gently until it clicks into place.
Open the drawer and make sure the disc is
properly seated. It should lie flat with the label
facing up.
A foreign object in the drawer could block laser
light from reading the disc. Make sure there is no
obstruction. Remove any foreign object.
Check whether the disc is dirty. If it is, wipe it with
a clean cloth dipped in water or a neutral cleaner.
See the
details on cleaning.
About the HD
Media Care section in Chapter 4 for
Troubleshooting
DVD.
10-13