Table of Contents
Advertisement
2DHD-I-0515
PROCEDURE FOR INSTALLING AND REMOVING ACCESSORIES
Direction
of
rotation
To install an accessory, there are several different types but all install in the same manner. On each of the accessory
holders there are (3) positions for accessories. To install an accessory slide accessory into holder in direction of white
arrows. Repeat for the other positions on this holder and then repeat for the other accessory holder.
To remove an accessory, there are several different types, all are removed in the same manner. To remove an acces-
sory slide towards the center of the accessory holder and out. If binding is encountered use a rubber mallet, not a
hammer, to tap it out of the holder.
NOTE: THE ABOVE ILLUSTRATION IS VIEWING THE MACHINE FROM THE FRONT BOTTOM.
PROCEDURE FOR LUBRICATING FLANGE BEARINGS
The hood has grease point access for the flange bearings as shown in the photo above left, two holes are located on
this side of the machine and one on the opposite. The grease points are circled in the photos above. There are duplicate
grease fittings on the underside of the machine in the photo on the right. The skirt will have to be removed to access
these grease points. There are a total of six (6) grease points, three (3) on top and three (3) on the bottom.
To grease the flange bearings attach the grease gun to the grease fittings and give only two (2) pumps on the grease
gun every 50 hours of use. If excessive over lubrication is done grease will leak onto the work surface causing pos-
sible damage and wasted cleanup time.
Printed in USA
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
©2015
Fax (301) 663-1607 • 1-800-447-3326
Page 8
Website: www.edcoinc.com
Email: sales@edcoinc.com
Direction
of
rotation
Three
grease
fittings
circled
in
photo
on
left.
Advertisement
Table of Contents
