Table of Contents
Advertisement
3. I/O Setting
a. Input Setting:
IP Camera supports input and output. When the input condition is triggered,
it can trigger the relay out, send the video to mail addresses /FTP server /
SAMBA.
• Intervel:
For example, if you select "10 sec" here, once the input alarm is
detected and action is triggered, it cannot be triggered again within 10
seconds.
• Based on the schedule:
When the option box is ticked, only during the selected schedule time
the I/O is enabled. That is, for example, the 11th hour of Monday has
not been colored in the schedule table, then no action will be triggered
even the camera detects input signal during 11:00~12:00 on Monday.
b. Output Setting:
The output mode affects the DO or relay out duration.
(i)
OnOff Switch: The camera triggers the external devise and lasts for
certain of time according to the event "interval" setting. If it's triggered
by motion detection, the triggering time is according to "interval"
setting of motion detection. If it's triggered by external input alarm, the
triggering time is according to input "interval" setting. It triggers the
external devise and lasts for 10 seconds if you select "10" in interval
setting. You can turn off the alarm manually by click "off" at the right
bottom of the live video page.
Time Switch: The camera triggers the external devise and lasts for
(ii)
certain of time according to the output "interval" setting, and the user is
not allowed to break off the alarm manually.
Advertisement
Table of Contents
