Environmental Protection; Disposal; Service - Bosch AQUATAK 150 PRO Operating Instructions Manual

F016 L70 375 - GB Seite 7 Montag, 14. November 2005 1:15 13

Environmental Protection

Chemicals dangerous to the environment must not
be allowed to enter the ground, ground water or
ponds, streams, etc.
For the use of cleaning agents, observe the instruc-
tions on the package and the prescribed concentra-
tion exactly.
For the cleaning of motor vehicles the local regula-
tions should be observed: Do not allow oil sprayed
off to enter into the ground water. Recycle raw ma-
terials instead of waste disposal.

Disposal

Power tools, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical and
electronic equipment and its incorpo-
ration into national law, power tools
that are no longer suitable for use must be sepa-
rately collected and sent for recovery in an environ-
mental-friendly manner.

Service

Exploded views and information on spare parts
can be found under:
www.bosch-pt.com
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham-Uxbridge
Middlesex UB 9 5HJ
✆
Service
................................
Fax Service
...............................
✆
Advice line
.........................
Fax Advice
.................................
19 • F016 L70 375 • TMS • 21.10.05
+44 (0) 18 95 / 83 87 82
+44 (0) 18 95 / 83 87 89
+44 (0) 18 95 / 83 87 91
+44 (0) 18 95 / 83 87 93
English - 7
Ireland
Beaver Distribution Ltd.
Greenhills Road
Tallaght-Dublin 24
✆
Service
....................................
Fax
....................................................
Australia and New Zealand
Robert Bosch Australia Pty. Ltd.
RBAU/SPT
1555 Centre Road
P.O. Box 66
3168 Clayton/Victoria
✆
................................................
Fax
................................................
www.bosch.com.au
Declaration of Conformity
Measured values determined
2000/14/EC (1 m distance away) and DIN 45 635.
Typically the A-weighted noise level of the product
is: sound pressure level 78 dB (A) (AQUATAK 150
PRO/PRO X); 79 dB (A) (AQUATAK 160 PRO);
sound power level 89 dB (A) (AQUATAK 150 PRO/
PRO X); 92 dB (A) (AQUATAK 160 PRO).
The typical hand/arm vibration is below 2.5 m/s
We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents: EN 60 335 according
to the provisions of the directives 89/336/EEC,
98/37/EC, 2000/14/EC.
2000/14/EC: The guaranteed sound power level
L is lower than 91 dB (A) (AQUATAK 150 PRO/
WA
PRO X); 94 dB (A) (AQUATAK 160 PRO). Conform-
ity assessment procedure according to Annex V.
Leinfelden, 01.01.2005.
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
Subject to change without notice
+353 (0)1 / 4 14 94 00
+353 (0)1 / 4 59 80 30
+61 (0)1 / 3 00 30 70 44
+61 (0)1 / 3 00 30 70 45
according to
2
.
Dr. Eckerhard Strötgen
Head of Product
Certification