Operation - Ariens Sno-Thro Hydro Pro 28 Track Owner's/Operator's Manual

1. Skid Shoes
2. Clean-Out Tool
3. Remote Discharge Chute Deflector
4. Belt Cover
5. Headlight
6. Auger
7. Auger Gearcase
8. Scraper Blade
9. Discharge Chute
10. Impeller
11. Chute Rod
12. Handlebar Hardware
13. Heated Hand Grips
14. Drift Cutters
15. Height Adjuster Trigger (926325, 514)
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: To avoid injury to hands
and feet, always disengage
clutches, shut off engine, and wait
for all movement to stop before
unclogging or working on snow
thrower.
Keep hands and feet away from
auger and impeller.
CONTROLS AND FEATURES
See CONTROLS and FEATURES on
pages 16 and 17 for all Controls and
Features locations.
Dual Handle Interlock
When Attachment Clutch and then Traction
Drive Clutch are engaged, the Attachment
Clutch will remain engaged (lever down) if
released. To stop attachment, release
Traction Drive Clutch and both clutches will
disengage.
16. Oil Drain
17. Fuel Shut-Off Valve
18. Primer Bulb
19. Recoil Starter Handle
20. Throttle
21. Choke Control Knob
22. Ignition Key
23. Fuel Tank and Cap
24. Oil Fill/Dipstick
25. Electric Starter
26. Attachment Clutch Lever
27. Speed Selector
28. Traction Drive Clutch Lever
29. Deflector Remote Control
30. Chute Control
31. Muffler Guard
32. Heated Hand Grips Switch
33. Electric Start 12V Key Start (926514,
517)

OPERATION

Traction Drive Clutch –
Left Hand Lever
2
1
NOTICE: When traveling to or from the area
to be cleared, press down on the handlebars
enough to raise the front of the unit slightly off
the surface. Engage the traction drive clutch
without engaging the attachment drive clutch.
EN - 17
Squeeze the Traction
Drive Clutch Lever
against the Handlebar
(1) to engage wheel
drive for propelling unit.
Forward speed will
vary according to snow
depth and moisture
content.
Release lever (2) to
stop movement.