Specifications - Mark Levinson 433 Owner's Manual

Rated power output:
Frequency response:
Signal to Noise ratio:
Input impedance:
Voltage gain:
Input sensitivity:
30
Power consumption:
Mains voltage:
Overall dimensions:
Shipping weight:
Net weight:
complement:
Output impedance:

Specifications

The correlation between published specifications and performance is unreliable.
Measurements of your amplifier yield excellent results by any standards. However,
only those specifications that apply to its actual operation are included here. Specifi-
cations are subject to change without notice.
• 200 w/ch rms power @ 8Ω
• 400 w/ch rms power @ 4Ω
All above power ratings from 20 Hz–20 kHz at <0.5% THD
(assuming that the AC mains can deliver adequate current, without
its own voltage sagging)
• within 0.2 dB from 20 Hz to 20 kHz
• better than –80 dB (ref. 2.83V)
• 100kΩ (balanced)
• 50kΩ (unbalanced)
• 26.8 dB
• 2.83V output: 130 mV
• Full output: 1.82V
• 200W in on, 100W in standby, 10W in sleep
• determined by the needs of country for which the unit was
manufactured; cannot be reset by dealer or user
See "Dimensions" on page 32.
• 130.5 lbs. (59.2 kg)
• 114.5 lbs. (51.9 kg)
• six custom binding posts
Connector
• three 3-pin XLR balanced input connectors
• three RCA input connectors
• two 1/8-inch mini-jacks for remote turn-on
• one RS-232 port on RJ-11
• two Mark Levinson communications ports on RJ-11, RJ-45
• one IEC-standard AC receptacle
• less than 0.05Ω from 20–20,000 Hz
Mark Levinson