Table of Contents
Advertisement
® ®
2.3 Mounting the RIM100
Attach the RIM100 securely to the vessel using the included stainless steel mounting screws
or other fasteners as shown in Figure 1 below.
Figure 1 – Mounting the RIM100
2.4 Connecting the RIM100
®
The RIM100 requires two types of electrical connections: 1) the NMEA 2000
connection (refer
to Section 2.4.1), and 2) the monitored load connections, which are described in Section 2.4.2.
®
2.4.1 NMEA 2000
Connection
®
®
The NMEA 2000
connector can be found on the side of the enclosure. The NMEA 2000
connector is a round five pin male connector (see Figure 2). You connect the RIM100 to an
®
®
NMEA 2000
network using a Maretron NMEA 2000
cable (or compatible cable) by
connecting the female end of the cable to the RIM100 (note the key on the male connector and
keyway on the female connector). Be sure the cable is connected securely and that the collar
on the cable connector is tightened firmly. Connect the other end of the cable (male) to the
®
NMEA 2000
network in the same manner. The RIM100 is designed such that you can plug or
®
unplug it from an NMEA 2000
network while the power to the network is connected or
®
disconnected. Please follow recommended practices for installing NMEA 2000
network
products.
Revision 1.0
Page 3
Advertisement
Table of Contents
