TMP100 User's Manual
-
Ambient Air Temperature Probe (-20°C to 80°C or -4°F to 176°F)
-
Ring Terminal Probe (-20°C to 80°C or -4°F to 176°F)
-
Immersion Probe for Tanks or Plenums (-20°C to 80°C or -4°F to 176°F)
-
Exhuast Gas Temperature Probe (0°C to 900°C or 32° to 1652°F)
1.3 TMP100 Accessories
Maretron offers the following Accessories for the TMP100:
• TR3K
• TP-AAP-1
• TP-IP-1
• TP-EGT-1
1.4 Quick Install
Installing the Maretron TMP100 involves the following five steps. Please refer to the individual
sections for additional details.
1. Unpack the box (Section 2.1)
2. Choose a mounting location (Section 2.2)
3. Mount the TMP100 (Section 2.3)
4. Connect the TMP100 (Section 2.4)
5. Configure the TMP100 (Section 2.5)
2 Installation
2.1 Unpacking the Box
When unpacking the box containing the Maretron TMP100, you should find the following items:
1 – TMP100 – Temperature Module
1 – Parts Bag containing 4 Stainless Steel Mounting Screws
1 – TMP100 User's Manual
1 – Warranty Registration Card
If any of these items are missing or damaged, please contact Maretron.
2.2 Choosing a Mounting Location
Please consider the following when choosing a mounting location.
1. The TMP100 is waterproof, so it can be mounted in a damp or dry location.
2. The orientation is not important, so the TMP100 can be mounted on a horizontal deck,
vertical bulkhead, or upside down if desired.
3. The TMP100 is temperature-rated to 55°C (130°F), so it should be mounted away from
engines or engine rooms where the operating temperature exceeds the specified limit.
Page 2
TMP100 Ring/Under Bolt Temperature Probe
TMP100 Ambient Air Temperature Probe
TMP100 Immersion (Tanks, Plenums, etc.) Temperature Probe
TMP100 Exhaust Gas Temperature Probe
Revision 1.0