Table of Contents
Advertisement
Table 17 Expert Mode: Status > System Status: Access Point Mode (continued)
LABEL
Rate
Printer Information
Printer Name
7.4.1 Navigation Panel
Use the menu in the navigation panel to configure ARMOR Z1 features in Access Point Mode.
Figure 31 Expert Mode: Navigation Panel: Access Point Mode
Refer to
Table 16 on page 38
7.5 LAN Screen
Use this section to configure your LAN settings while in Access Point Mode.
Click Expert > LAN to see the screen below.
Note: If you change the IP address of the ARMOR Z1 in the screen below, you will need to
log into the ARMOR Z1 again using the new IP address.
Chapter 7 Access Point Mode
DESCRIPTION
For the LAN ports, this displays the port speed and duplex setting or is left blank when the
line is disconnected.
For the 2.4GHz/5GHz WLAN, it displays the maximum transmission rate when the 2.4GHz/
5GHz WLAN is enabled and N/A when the WLAN is disabled.
The ARMOR Z1 can act as a print server and allows you to share a USB printer on your LAN.
This displays the name of the printer connected to the ARMOR Z1's USB port.
Note: You need to manually install the printer driver in your computer and add the printer to
your printer list.
for descriptions of the labels shown in the navigation panel.
ARMOR Z1 User's Guide
45
Advertisement
Table of Contents
