Tool Set Up - Chicago Electric 62302 Owner's Manual & Safety Instructions

Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.

Tool Set Up

TO pREVENT SERIOUS INJURy FROM ACCIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical
outlet before adjusting tool or installing accessories.
1. Turn the Power Switch off and unplug the tool.
2. Place the attachment over the Spindle, shoulder
facing away from the tool. Line up the holes on the
attachment with the pins on the Spindle shoulder.
Note: The Angled Cutter Blade should only be used in
the straight ahead position and not an angled position.
3. Slide the Small Washer, then the Large Washer
onto the Cap Screw. Make sure the cupped
side of the Large Washer is toward the tool.
While holding the attachment over the pins on
the tool, thread the Cap Screw in place.
Item 62302
Angled Cutter
Place Large
Washer,
cupped side down
For technical questions, please call 1-888-866-5797.
4. Tighten the cap screw onto the
Spindle using the provided Hex Key.
Torque snugly (approximately 10 ft-lb).
5. After securing, the attachment should not move on
the spindle. If it can move with the power off,
remount it, making sure that the holes on the
attachment line up with the pins on the spindle.
Tighten the cap screw securely.
Torque to 10 ft-lb
Page 9