Inglesina telai easy clip Instruction Manual page 16

UK
16
CARE AND MAINTENANCE
This vehicle requires regular maintenance
by the user.
Never force mechanisms or moving parts.
If you are not sure what to do, refer to the
instructions.
Clean plastic and metal parts with a damp
cloth or a light detergent.
Do not use abrasive, ammonia based,
bleach based or spirit type cleaners.
Keep the vehicle in a dry place. If wet, dry
the metal parts to prevent rusting.
Excessive and prolonged exposure to
sunlight and/or rain may cause the fabric
or plastic to fade or change colour.
Periodically lubricate moving parts with
light oil, making sure the oil penetrates the
LEGEND
A Chassis base
B Front wheels
C Rear wheels with brake latch
D Handle
E Chassis closing devices
F Handle adjustment push-buttons
(only for ERGO BIKE version)
G Brake bar
H
(on all wheels)
I
L Additional transport unit
hooking system
M Basket
N Safety lever
O Air pump
(only for ERGO BIKE version)
ASSEMBLY OF COMPONENTS
1 Check that all components of the chassis
wheels (B), two rear wheels (C), small air
pump (only for ERGO BIKE version).
HOW TO OPEN THE CHASSIS
2 Open the chassis base by pulling the
handle (D) upwards.
3 Press the handle (D) downwards until
hearing a CLICK indicating that both
closing devices (E) have been hooked.
WARNING
INSTRUCTIONS
A), two front
mechanisms deeply.
If the stroller has been used on the beach,
clean it so as to remove sand or salt from
the mechanisms and wheels.
Do not use bleach. Allow the stroller to dry
completely before using or storing it.
Follow upholstery washing instructions as
shown on the labels.
Pushchairs and prams should be serviced
after an extended period of no use.
WARNING: Make sure that the closing
devices (E) are properly hooked to the
Only for chassis ERGO BIKE version:
ADJUSTMENT OF THE HANDLE
4 Press the push-buttons (F), positioned
on both sides of the handle, and rotate this
latter upwards simultaneously.
ASSEMBLY OF THE REAR WHEELS
5 WARNING: Two of the wheels
supplied with the chassis are equipped
(C) have to be assembled on the rear
axis of the chassis, near to the brake
6 Make sure that the brake bar (G) is
positioned upwards (in brake release
position).
7 Lift the chassis base (A) and hold one
of the rear wheels (C). Pull the hook (H)
present on the wheel upwards and then
insert the wheel in the pin (I).
8 Push the wheel (C) towards inside and
release the hook (H) until hearing a click
indicating that it has hooked properly.
9 WARNING! Verify that the wheel is
properly hooked pulling it towards