BLUE EMBER GRILLS FG50069 Assembly Manual And Use And Care

BLUE EMBER GRILLS FG50069 Assembly Manual And Use And Care

Outdoor gas barbeque/grill

Advertisement

Outdoor Gas
Barbeque/Grill
Assembly manual
and Use and Care
MODEL
FG50069
!
WARNING!
Hazardous Fire or Explosion may result
if these instructions are ignored.
It is your responsibility to see that your new
barbeque is assembled, installed, maintained
and cared for properly. Failing to carefully
follow the instructi o ns in this manual could
result in serious bodily injury and/or
property damage.
WARRANTY INFORMATION
Full Model No.
from outer carton:
Date Purchased:
Serial Number
(
:
from rating plate)
SAVE THIS MANUAL FOR FUTURE REFERENCE
Installer must leave instructions with the consumer for future reference.
KEEP YOUR RECEIPT AS PROOF OF PURCHASE TO VALIDATE
THE WARRANTY. ATTACH YOUR RECEIPT TO THE INSIDE
COVER OF THIS MANUAL FOR EASY REFERENCE.
MANUFACTURED FOR:
Fiesta Gas Grills, LLC.
One Fiesta Drive
Dickson, TN USA 37055
Made in China
THIS APPLIANCE IS FOR OUTDOOR USE ONLY
DANGER!
!

IF YOU SMELL GAS:

1. Shut off gas supply to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, keep away from the appliance
and immediately call your gas supplier or your
fire department.
!
WARNING!
1. Do not store or use gasoline or other flammable
liquids or vapors in the vicinity of this or any
other appliance.
2. An LP cylinder not connected for use shall not be
stored in the vicinity of this or any other
appliance.
!
CAUTION!
Some parts may contain sharp edges
especially if noted in the manual!
Wear protective gloves if necessary.
1-800-396-3838
www.blueembergrills.com
-
SP5473-37 Rev C

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FG50069 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for BLUE EMBER GRILLS FG50069

  • Page 1: If You Smell Gas

    Outdoor Gas Barbeque/Grill Assembly manual and Use and Care MODEL FG50069 WARNING! DANGER! IF YOU SMELL GAS: Hazardous Fire or Explosion may result 1. Shut off gas supply to the appliance. if these instructions are ignored. 2. Extinguish any open flame.
  • Page 2: Table Of Contents

    THANK YOU FOR Please retain this manual for the lifetime of your barbeque after recording the serial and model PURCHASING THIS BARBEQUE number in the appropriate space allocated on the front cover. We are dedicated to creating the ultimate • The serial number can be found on the silver barbeque experience by providing you with...
  • Page 3: Getting Familiar With Your Barbeque

    GETTING FAMILIAR WITH YOUR BARBEQUE DO NOT USE YOUR BARBEQUE UNTIL YOU HAVE Fig. 1 READ AND UNDERSTOOD ALL THE 10mm CASTING WARNING INFORMATION IN THIS MANUAL. IT IS EXTREMELY IMPORTANT TO BE SURE THAT: BEFORE YOU USE THIS APPLIANCE •...
  • Page 4: Electrical Caution

    CARING FOR YOUR EQUIPMENT PROVIDING POWER TO YOUR BARBEQUE ELECTRICAL CAUTION To provide power to the barbecue, plug grounded electrical cord into • If any accessory installed on this barbeque requires an external electrical rear electrical box as shown. Page 14 (Fig.15) power source, it must be electrically grounded in accordance with local laws or in the absence of local laws, with the Canadian Electrical Code Plug electrical cord into properly grounded...
  • Page 5: Transportation And Storage

    TRANSPORTATION AND STORAGE: ALTHOUGH IT IS SAFE WHEN USED PROPERLY, CARELESS HANDLING OF THE PROPANE GAS CYLINDER WARNING COULD RESULT IN FIRE, EXPLOSION, AND/OR SERIOUS INJURY. PROPANE GAS IS HEAVIER THAN AIR, AND WILL COLLECT IN LOW AREAS, INCREASING THE ABOVE RISKS. THEREFORE: •...
  • Page 6: Hose & Regulator

    HOSE & REGULATOR NOTE: IMPROPER LIGHTING PROCEDURES CAN CAUSE THE FLOW CONTROL TO ACTIVATE, RESULTING IN REDUCED HEAT OUTPUT. IF THIS IS SUSPECTED, RESET THE FLOW CONTROL BY SHUTTING OFF ALL BURNER CONTROLS AND THE CYLINDER VALVE. WAIT 30 SECONDS, THEN TURN THE CYLINDER VALVE WARNING: INDICATES AN POTENTIALLY ON EXTREMELY SLOWLY - WAIT 5 SECONDS AND TURN THE BURNER VALVE HAZARDOUS SITUATION WHICH, IF NOT AVOIDED,...
  • Page 7: Cleaning & Maintenance

    CLEANING & MAINTENANCE HOW TO DO THE TESTING: To keep your barbeque working at its peak efficiency as well as contribute to the safe operation of this 1. With the barbeque console control knobs in the ‘OFF’ posit ion, twist the valve on your propane cylinder 1 turn, or the main natural gas valve on.
  • Page 8: Cleaning Other Parts Of Your Appliance

    CASTING INTERIOR AND WARMING RACK: CLEANING OTHER PARTS OF At least once a year remove all components from inside your barbeque. YOUR APPLIANCE Loosen any cooking residue with a scraping tool for large particles and a brass barbeque brush for smaller particles. Scrub with hot water and a General Grill Cleaning: Do not mistake brown or black accumulation strong detergent, then rinse thoroughly or spray barbeque degreaser liberally on all interior surfaces.
  • Page 9: Using Your Appliance Correctly

    USING YOUR APPLIANCE CORRECTLY Fig. 9A WARNING: ENSURE SIDE BURNER LID IS UP BEFORE LIGHTING SIDE BURNER. INTERNAL LIGHT LEFT BURNER ROTISSERIE BURNER CENTER BURNER IGNITOR MODEL MAY NOT BE EXACTLY AS SHOWN. SIDE BURNER PARTS OPTIONAL (READ WARNING) DEPENDING ON MODEL PURCHASED RIGHT BURNER GETTING FAMILIAR...
  • Page 10: Lighting

    LIGHTING IF LIGHTING MAIN BURNERS ONLY, ENSURE SIDE BURNER KNOB IS IN THE OFF Prior to lighting your barbeque,visually check all hoses before each CAUTION use for nicks, cracking, abrasions or cuts. If the hose is found to be POSITION. damaged in any way, DO NOT USE YOUR BARBEQUE.
  • Page 11: Side Burner

    SIDE BURNER (OPTIONAL) USING THE IGNITOR 1. Raise side burner lid. 2. Push in and turn the side burner control knob to 'HIGH'. 3. Depress ignitor. Repeat if necessary (see Figure 12A). 4. If burner does not light immediately (within five seconds), turn the burner control knob off, and wait 5 minutes to clear the gas.
  • Page 12: Relighting

    REAR ROTISSERIE Fig. 12D BURNER (OPTIONAL) USING THE IGNITOR 1. Open the lid before lighting. 2. Push in and turn the rotisserie control knob to 'HIGH'. 3. Depress ignitor. Repeat if necessary (see Figure 12D). 4. If burner does not light immediately (within five seconds), turn the burner control knob off, and wait 5 minutes to clear the gas.
  • Page 13: Cooking Techniques

    Use of a Rotisserie motor is one of the fastest growing barbeque COOKING TECHNIQUES cooking techniques, especially if your barbeque is equipped with a rear rotisserie burner. Just imagine, cooking restaurant style PREHEATING THE BARBEQUE rotisserie meat in your own backyard! Rotisserie cooking allows the The cooking system and grids require heating prior to adding food.
  • Page 14: Providing Power To Your Barbeque

    PROVIDING POWER TO YOUR BARBEQUE To provide power to the barbecue, plug grounded electrical cord into rear electrical box as shown. (Fig.15) Plug electrical cord into properly grounded GFI (Ground Fault Interrupt) receptacle. If use of an extension cord is required, be sure that it is a minimum 16 AWG, TRANSFORMER 3 wire well insulated cord, marked...
  • Page 15: Trouble Shooting Guide

    TROUBLE SHOOTING GUIDE PROBLEM POSSIBLE CAUSES CORRECTION Burner Will Not Light (match or ignitor) • Blocked venturi tubes • Clean out blockage (Page 7) or Burners Not Hot Enough • Cylinder or gas supply valve turned off • Open cylinder or gas supply valve •...
  • Page 16: Warranty Information

    LIMITED WARRANTY 1. LIMITED WARRANTY COVERAGE 7 YEAR LIMITED WARRANTY - STAINLESS STEEL BURNERS 2 YEAR LIMITED WARRANTY - ALL OTHER PARTS Blue Ember gas barbeque owners have the benefit of a limited warranty from the date of purchase against any and all defects in materials and workmanship during the period of warranty coverage specified.
  • Page 19: Tools Required

    CASTER ASSEMBLY F F I I G G . . 1 1 NOTE: Assembled Some grill parts shown in the assembly steps View may differ slightly in appearance from those on your particular grill model. However, the method of assembly remains the same. TOOLS REQUIRED: •...
  • Page 20 BASE CABINET ASSEMBLY • Attach Cabinet side panels to base as shown. Assembled NOTE: Right panel has two holes located on View the top right corner for bottle opener. • Attach bottle opener to right panel as shown. SP53-16 (2) 1/4-20 NUT HEX HD FLANGED Right hand Panel...
  • Page 21 REAR PANEL ASSEMBLY • Attach rear panel by sliding notches over screws on side panels as shown. Tighten screws. • Install Electrical box with Screws and Nuts as shown. Ensure Electrical box is installed so outlet covers open upwards. • Install Transformer box into rear panel holes as shown. Assembled View INSTALL SO OUTLET...
  • Page 22 TRIM PANEL & HEAT SHIELD ASSEMBLY • Attach top trim panel as shown. Tighten nuts. • Attach heat shield as shown. Tighten screws SP61-21 (4) 10-B X .375 SCREW SELF TAP SP53-16 (4) 1/4-20 Assembled NUT HEX HD FLANGED View SP83-18 (4) 1/4"-20X.50"...
  • Page 23 FRONT DOOR ASSEMBLY Assembled View • Install door handles as shown. • Slide top pins on doors into upper holes as shown. • A) Drop locking pins through lower holes in door into base assembly. #10-24 NUT HEX HD • B) Once in position rotate pins into FLANGED HANDLE locked position as shown.
  • Page 24 CASTING ASSEMBLY REGARDING IMPROPER ASSEMBLY OF HOSE ON PROPANE AND NATURAL GAS FG500 MODELS. DURING THE ASSEMBLY PROCESS OF THE BASE ASSEMBLY STEP, THE CUSTOMER NEEDS TO ENSURE THAT THE HOSE IS UNTIED FROM BURNER BEFORE FINAL ASSEMBLY. CUSTOMER SHOULD RELEASE THE TIE AND PASS THE HOSE THROUGH THE GAP IN BETWEEN HEAT SHIELD AND FRONT PANEL BEFORE ASSEMBLING THE FIREBOX (BASE) TO THE CART (CABINET).
  • Page 25 GRILL ASSEMBLY F F I I G G . . 7 7 Step 2 Step 3 Step 1 Step 1 • Rest the ends of heat plates into notches inside casting as shown. Step 2 • Install Smoker on hooks inside cover assembly. Step 3 •...
  • Page 26 SIDE SHELF ASSEMBLY F F I I G G . . 8 8 Assembled View • Position side shelves onto shelf brackets as shown (A). Lift shelf and drop into locking position (B). Insert wingbolt into middle hole in bracket to lock shelf in position (C).
  • Page 27 SIDE BURNER HOSE ASSEMBLY • Position hose into end of side burner venturi tube until groves line up (A). Snap clip into the groove on side burner tube to secure parts (B). • Check hose to ensure it is securely positioned in tube end. •...
  • Page 28 GREASE TRAP ASSEMBLY • Assemble grease pan with brackets as shown using (4) 10-b x .375 screw self tap Grease Pan screws. .375 self tap screw • Slide in grease pan and Grease tray as shown. Bracket • Ensure grease pan and tray are in position before using the BBQ.
  • Page 29 TANK ASSEMBLY • Position tank into tank support as shown. Assembled View TANK NOT INCLUDED F F I I G G . . 1 1 2 2 HOSE/REGULATOR WARNING: Before proceeding with the following steps, ensure you have read: • L.P. Gas Cylinder • Hose and Regulator Sections of the USE AND CARE INSTRUCTIONS located at the front of this manual.
  • Page 30 BULB REPLACEMENT INSTRUCTIONS NOTE: UNPLUG ALL POWER TO GRILL BEFORE REPLACING LIGHT. 1. Loosen two nuts. 2. Press tab on top of Glass Bezel. Light Rain Guard Reflector BULB Glass Gasket 4. Hold the Light Rain Guard, 3. Hold the Light Rain Guard, slowly remove the light BULB.
  • Page 31 DESCRIPTION ITEM QTY. SP PART No. SP155-42X COVER ASSY SP37-33X COVER CAST END CAP LH SP38-33X COVER CAST END CAP RH SP87-9 COVER PANEL SP88-9 COVER LINER SP53-19 HANDLE SP43-33 COVER PLUG SP54-21 #10-24 X .5 RD HD SS PHILIP SP40-16 SELF-THREAD LOCKNUT 1/4"...
  • Page 32 Gas Barbeque Grill: ITEM QTY. SP PART No. DESCRIPTION SP166-42X PANEL LH ASS'Y Model FG50069 SP106-9X PANEL SIDE LH SP56-6B CART BRACKET LH - BLACK HOW TO ORDER SP46-21 1/4" x 1/2" SCREW HEX HD SELF TAP B SP104A-9X BOTTOM PAN RESIN...

Table of Contents

Save PDF