Ost Nstallation Hecks; Rick Nstallation; Check - Lennox Hearth Products STRIKER S160 Installation And Operation Manual

P i c
osT nsTallaTion hecks
1. Check that all chimney pipe joints are securely fas-
tened.
2. Check that the heater is securely fastened to the floor
(if applicable).
3. Make sure the intake vent has clear access to outside
air (if applicable).
4. Make sure the outside air vent has been sealed
properly to keep rodents out (if applicable).
5. Be sure all roof flashings are watertight.
6. Be sure the stove is properly grounded (if appli-
cable).
FOR YOUR OWN PROTECTION AND INSURANCE
PURPOSES, HAVE YOUR CHIMNEY AND CONNECTOR
PIPE INSTALLATION INSPECTED BY YOUR LOCAL
BUILDING CODE AUTHORITY OR FIRE MARSHAL
BEFORE STARTING A FIRE IN YOUR STOVE. NOTIFY
YOUR INSURANCE COMPANY.
B
rick
CAUTION: Wear gloves during brick installation in
case of sharp edges inside the stove.
Note: Installation of the baffle bricks and insulating blanket
is easier when you can still access the flue outlet, (before
connecting the flue pipe). Be sure the insulating blanket is
placed flat on the bricks so as not to block the flue. Use a
ruler or a piece of kindling to reach over the blanket to be
sure it is completely flat on top of the baffle bricks.
Measure bricks before installing, as per list of dimensions
on next page, to be sure the correct bricks are installed in
the correct location.
1. Install bricks #1-18 in the numbered sequence shown
2. Next, install bricks #19 & 20 into the rear stainless
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
i
nsTallaTion
in Figure 6 on the next page.
steel baffle support (see Figures. 7 & 8 on the next
page).
11