Maintenance - OHAUS Valor 2000 Series Instruction Manual

EN-10
When accessing the bottom of the scale, avoid placing the scale upside
down on the pan or sub-platform. Place the scale on its side.
5.2 Verification
Before this product can be used in a trade approved application, it must be inspected
in accordance with local weights and measures regulations. It is the responsibility
of the purchaser to ensure that all pertinent legal requirements are met. Please
contact your local weights and measures office for further details.
5.3 Sealing
The weights and measures official can apply a wire or paper security seal as shown
below.

6. MAINTENANCE

CAUTION: to avoid possible water entry, before cleaning the scale:
• Turn off the scale, remove the AC adapter and install the rubber seal securely.
• Screw in the two rear leveling feet tightly. When the scale is put back into
operation, remember to loosen the two rear feet to allow proper airflow inside the
scale.
Figure 5-1. Lock Switch.
SEAL
SEAL
Figure 5-2. Sealing.
Valor 2000 Series Scales
Lock Switch