Table of Contents
Advertisement
1-3. PWA POWER CIRCUIT DESCRIPTION
1. Outline
This is the main power circuit, and is comprised of the follow-
ing blocks.
Switching power controller (IC501)
Digital VDD3 output system (L5004)
Digital VDD1.2 output system (L5003)
Digital VDD1.8 output system (IC501-LD0)
Analog +13.0 V (A) output system (L5007)
Analog -7.5 V (A) output system (L5008, Q5008)
Analog +3.5 V (A) output system (IC502)
LCD backlight output system (L5006, Q5006)
Motor system BOOST 4.2 V output system
(L5301, D5301, Q5301)
2. Switching Controller (IC501)
This is the basic circuit which is necessary for controlling the
power supply for a PWM-type switching regulator, and is pro-
vided with seven built-in channels and one built-in channel
(LD0).
Only CH1 (motor system), CH2, CH3 and CH4 (digital sys-
tem), CH7 and CH8 (analog system) and CH6 (LCD back-
light system) are used.
Feedback from motor system (CH1), digital system (CH2, CH3
and CH4), analog system (CH7 and CH8) are received, and
the PWM duty is varied so that each one is maintained at the
correct voltage setting level. (CH2 is output by LD0.)
Feedback for the LCD backlight power output (CH6) is so that
regular current can be controlled to be current that was set-
ting.
2-1. Short-circuit protection circuit
If CH3-CH8 output are short-circuited, CH2-CH8 are turned
off. To reset output, it is necessary to reset the contrller IC to
reset the power.
3. (CH1) Motor System 4.2 V Output
4.2 V is output. Feedback for the BOOST 4.2 V output is pro-
vided to (Pin (C5) of IC501) so that PWM control can be car-
ried out.
4. (CH2) Digital 1.8 V Output
+1.8 V is output. Feedback for the VDD1.8 output is provided
to (Pin (B3) of IC501) so that PWM control to be carried out.
5. (CH3) Digital 1.2 V Output
+1.26 V is output. Feedback for the VDD1.2 output is pro-
vided to (Pin (E2) of IC501) so that PWM control can be car-
ried out.
6. (CH4) Digital 3.25 V Output
+3.25 V is output. Feedback for the VDD3 output is provided
to (Pin (F2) of IC501) so that PWM control can be carried out.
7. (CH6) LCD Backlight Output
Regular current is being transmitted to LED for LCD back-
light. Feedback for the voltage to step-down LED is provided
to (Pin (B5) of IC501) so that PWM control to be carried out.
8. (CH7) Analog 13.0 V Output
+13.0 V is output. Feedback for the +13.0 V (A) output is pro-
vided to (Pin (E7) of IC501) so that PWM control can be car-
ried out.
9. (CH8) Analog -7.5 V Output
-7.5 V is output. Feedback for the -7.5 V (A) output is provided
to (Pin (C7) of IC501) so that PWM control can be carried
out.
– 7 –
Advertisement
Chapters
Table of Contents
