Device Connection
1.Connect GSM/GPS antennas to device;
2. Connect RFID to USB port of device;
2.Power I/O cable connect to I/O interface, and then connect GND and power cable to
negative and positive of power source(12V,2A),when LED lights of tracker start blinking,
that mean connection complete.
LED Light Status
The below table show the status of LED lights, you can know if it work as normal accordingly
LED
GSM LED Light
(Green)
GPS LED Light
(Red)
ONER GPS Vehicle Tracker
User Manual
STATUS
Off
Blinking fast
Blinking slow
Blinking 0.5sec,off 1.5sec
Standby
Off
Blinking fast
Blinking slow
Blinking 0.5sec,off 1.5sec
Standby
DESCRIPTION
Power off
Initializing
Signal searching....
Working
Failure
Power off
Initializing
Signal searching....
Working
Failure
Getting Starts
4