Device Connection; Led Light Status - Oner OCT600 User Manual

Device Connection

Power I/O cable connect to I/O interface, and then connect GND and power cable to
negative and positive of power source(12V,2A)，when LED lights of tracker start blink-
ing, that mean connection complete.

LED Light Status

The below table show the status of LED lights, you can know if it work as normal accordingly
The below table show the status of LED lights, you can know if it work as normal accordingly
LED
GSM LED Light
(Green)
GPS LED lights(Red)
ONER GPS Vehicle Tracker
User Manual
STATUS
Off
Blinking fast
Blinking slow
Standby
Off
Blinking slow
Standby
DESCRIPTION
switch off/SIM card detect failed
have GSM network, do not connect to tracking system
already connect to tracking system
failure
switch off
seaching GPS signal
Gain GPS singal, working as normal
Getting Starts
4