Running Mode - JVC KW-V11E Service Manual

<When INITIALIZE terminated abnormally>
Determine error in each block of SYSTEM/ DISC/ BT.
• In case of Bluetooth, Initialize Error is also considered as ab-
normal termination
Discontinue process once NG is detected, and display the corre-
sponding error as follows.
NG SYSTEM: Clearing of the unit set EEP (APP management
and SYS management) terminated abnormally
NG DISC: Clearing of DISC module EEPROM terminated abnor-
mally.
NG BT: BT module initialization terminated abnormally.
The below screen is retained until the [EXIT] key is pressed.
When the [EXIT] key is pressed, normal screen is brought back.
[EXIT] key: Return to the normal display by canceling the service
mode.
4.2.2.2 TEMPERATURE
Displays DISC module temperature (displays in 3 digits).
Acquires data from the module and updates the display every 30
seconds, as is done in the normal operation mode.
4.2.2.3

RUNNING MODE

DVD MODE5: Displays the currently selected mode
COUNT: Counter display
DVD ERROR: Displays the error code for error in the DISC
mecha (display as 000000 when there is no error)
DOOR ERROR: Displays the error code for error in the door
mecha (display as 000000 when there is no error)
*Immediately after moving to the RUNNING MODE, hide the dis-
play of all the above. Display the above items after an item is se-
lected.
[BACK] key: Goes back to the service mode. *Only valid before
selecting an item. Not valid after a selection is made.
Mode Cancel Key
• DOOR MODE can be canceled using the EJECT hard key.
• DVD MODE can be canceled using the Power Off hard key.
(1) DOOR MODE
Execute Door mecha running mode 1.
(Not valid for models without door mecha.)
2th line display: DOOR MODE 1
3th line display: Display the number of runs in 6 digits.
4th line display: Nil
5th line display: Display as "000000" when there is no door
(2) DVD MODE 1 to 6
Execute DVD running mode 1 to 6
(For models with door mecha, OPEN/CLOSE the door in
sync with DISC LOAD/EJECT.)
2th line display: DVD MODE 1
3rd line display: Display Arg 5,6,7 (BCD) of the "Unit re-
4th line display: Display Arg 2,3,4 (HEX) of the Unit request
5th line display:
(No.MA601<Rev.001>)19/30
mecha error, display the door mecha error
code when an error has occurred.
quest" (running status) received from
DISC module in 6 digits.
(running status) received from DISC mod-
ule in 6 digits.
<No door mecha>
Nil
<With door mecha>
Display as "000000" when there is no door
mecha error. Display the door mecha error
code in the event of an error.