Sharp LC-32LE700E Service Manual page 25

13. Removing of Bezel Ass'y, Panel Chassis Ass'y, Lens Sheet, Diffusion Plate, Back Light Chassis and LCD
Control Unit (52 inch models).
NOTE: A clean booth is required for repair of the component units and/ or parts (LCD Panel HIRAKI, LED PWB etc.) inside the LCD panel module
unit.
1. Remove the 9 lock screws
2. Remove the 6 Clip and detach the 52" LCD Panel HIRAKI Unit and Panel Chassis Ass'y
3. Detach the Optical Sheet
4. Remove the 43 Push Rivets
5. Remove the 72 Push Rivets
6. Remove the 12 Terminators
7. Detach the 6 LED6 PWB1 Units
8. Disconnect the connecting cords from the 12 connectors
9. Detach the Back Light Chassis
10.Detach the 2 Connecting Cord
11.Remove the 6 lock screws
LC-32/40/46LE700E/RU/S,LU700E/S,LX700E/RU,LC-52LE700E/RU/S
, 3 lock screws 18 lock screws
and Lens Sheet and Diffusion Plate
and 11 Support Pins and detach the Reflection Sheet
.
and 24 connections and detach the 12 LED8 PWB1 Units
and 6 LED6 PWB2 Units
.
and 2 Ferrite Core .
and detach the LCD Control Unit
and detach the Bezel Ass'y
.
.
of the LED6 PWB1/2 Unit.
4 – 14
.
.
.
and 12 LED8 PWB2 Units .