This is a step by step guide that will walk you through installing the UCIT PRO-4 Channel Camera System. Basic wiring experience and knowledge is required at the minimum. Please follow each step, otherwise your system may not work properly. If you have any questions regarding the installation of this system contact Support at 815-725-4400 or Support@DriverLocate.com.
Review packing list or “whats in the box” to make sure you have everything. NOTE: Any modifications to the device or software outside of company standards or without company approval are not a responsibility of Safety Track and may void the warranty. Getting Started: Familiarize yourself with the contents of the box.
Page 4
Step 1: Find a suitable location to mount the DVR in such a way that is accessible to the fleet manager. (To pull SD card and for troubleshooting) Step 2: Securely Mount DVR (Installers choice) by way of self-taping screws, zip ties, double sided tape etc. Step 3: Run the GPS and Comm Antennas (Anywhere that has a direct sightline to the sky...
Page 5
Step 5: Run camera cables with supplied 5 meter extension cables. Ensure proper connection, use electrical tape if needed. V - Video Output A - Audio Output 1. Camera 1 Video Input 2. Camera 2 Video Input 3. Camera 3 Video Input 4.
Page 6
Step 7: Start the vehicle and make sure you see lights on the DVR near the SD card slot on the front. This will ensure a proper connection. On the side of the DVR you will see a little BLUE switch.