Advertisement
Next, locate the standard 1/4" to 1/4" instrument cable. Insert one end of the cable into the
1/4" jack on the rear of the Mo' Control. This jack is located just to the left of the DB9 jack
you've just connected, and has a large text box above it that reads "To Mo' Bass Internal EFX
Bypass Jack Only." Now take the other end of the cable and insert it into the "Internal EFX
Bypass" jack on the rear of your Mo' Bass. Now you're fully connected, and you can switch on the
Mo' Bass.
We can hear you thinking: "What happens if I lose these cables?" Both cable are standard and
are easily replaceable. The 25-foot male-to-female DB9 cable is available at any computer sup-
plies store. The instrument cable (used for the Mo' Bass Internal EFX Bypass) is also easily
replaceable at most audio electronics retailers. Your Mo' Control comes with 25-foot versions of
each cable, and you can always contact the factory for replacement on either cable if you wish.
Finally, on the rear of the Mo' Control, locate the switch to the far right marked "Preset Group
Mode" and set the switch to "Program" (to the right). Now we're ready to play.
OPERATING THE MO' CONTROL
Individual Effects
We need to establish a term for when Mo' Control is in its most basic state, which is when no
Preset Groups are activated. Let's call it Solo Mode, since that's the opposite of a group (and
Alone Mode just sounds so lonely). When in Solo Mode, operation is simple. Step on any one of
the switches for the individual effects, and three things will happen: a) The effect will activate on
the Mo' Bass; b) The LED will illuminate on the Mo' Control; and c) The LED will illuminate on the
Mo' Bass.
To disengage any activated effect, simply step on the switch again and it will shut off. Individual
switches will not affect other individual switches. You can turn the effects on and off one at a
time, or manually turn on several effects at once. Notice that whatever you do on the Mo' Control,
the Mo' Bass LEDs will reflect. The reverse is also true. If you engage an effect manually by using
the switch on the Mo' Bass itself, the corresponding Mo' Control LED will illuminate. In essence,
the two units are joined at the hip.
TO MO'BASS INTERNAL
FX BYPASS ONLY
MO' CONTROL USER GUIDE
4
Advertisement
