Advertisement
Pedal Specifics
BOSS™ pedals are generally powered by one of two types of voltage, identified on the label as
"PSA" or "ACA". Most all BOSS™ pedals are "PSA" type and require standard 9VDC. "ACA" pedals
will operate correctly using any 12VDC output on the Hot Stone. BOSS™ Twin pedals require
higher current and can be operated from output 1 or 2 at 9V.
Line 6™ Modeling pedals (4 button type) can be operated from output 1 or 2 at 12V. The BLUE
5.5x2.5mm cable must be used for these pedals.
TC Electronic™ Nova pedals can be powered using the standard BLACK cable from output 1 or
2 at 12V. Some pedals such as the NDR-1 Nova Drive require higher current and can only be
powered by using a current doubling cable with outputs 1 & 2.
Eventide™ "Factor" pedals can be powered from output 1 or 2 at 12V using the BLUE
5.5x2.5mm cable.
Strymon™ pedals can be powered from output 1 or 2 at 9V using the standard BLACK cable.
Other pedals will list power requirements in their manual or on the pedal itself. Some
manufacturers list actual power requirements, while others may list only the rating of the
included or recommended adapter. Often a pedal will use much less power than the
recommended adapter rating. If you are unsure of your pedals requirements, please check our
www.decibel11.com
support@decibel11.com
website at
or email support at
.
Specification
OUTPUTS:
All outlets: 5.5x2.1mm barrel connectors, center negative.
All outlets: regulated and filtered DC voltage, short circuit protected.
Outlet 1-2: 9V and/or 12V, 400mA
Outlet 3-4: 9V and/or12V, 400mA
Outlet 5-8: 9V, 100mA each
INPUT:
115V/230V, 50/60Hz switchable
PHYSICAL:
Dimensions (WxDxH): 5.83" x 3.46" x 1.73"
Weight: 2.6 lbs.
DECIBEL11.COM
Advertisement
