Repair Introduction; Mechanical Repairs; Basic Modular Troubleshooting - Motorola L7082 Service Manual

Level iii l7082 - single band 1900 mhz gsm l7089 - tri-band 900 / 1800 / 1900 mhz gsm

Hide thumbs Also See for L7082:

Table of Contents

L7082 / L7089

6.1 Repair Introduction

The L7082 / L7089 is divided into 3 main sections when it comes to part replacability: The housings which

contains the alert, speaker, mic, the main PCB which contains RF / Logic circuitry and the keypad

interface and finally the display module which connects to the main PCB via a elastomer connector. If

the RF / Logic board is required to be changed then a full service tranceiver should be ordered as there

is no replacement PCB available. Also a personality transfer would be necessary.

6.2

Assembly replacement level troubleshooting and repair of the L7082 / L7089 is limited to isolation and

replacement of the main mechanical parts only (See Exploded parts diagram and associated parts list

p19 & p20)

6.3

The troubleshooting information in Table 2 shows some typical malfunction symptoms, and for the

corresponding verification and repair procedures refer to the disassembly instructions located in the

disassembly section of this manual. (Section 4).

NOTE

of 48

Defective Logic/RF assemblies must be replaced

with pre-tested, pre-phased assemblies

Table of Contents

L7089