Memrecam GX-5 User Manual page 80

3.2.10.6.4 MULTIS(A)
Figure 3-34 shows how to switch modes with the JPAD3 during MULTIS (A) recording (top of the figure) and
saving in the memory (bottom of the figure). MULTIS (A) is multi trigger recording in AUTO mode.
The sequences for setting two memory segments and four blocks, and for MULTIS (A) recording to all of the
memory segments are shown below.
The memory should be empty before recording is started.
VIEW STOP
ARM REC ARM REC
B1 B2
Figure3-34 Multi Trigger Recording (MULTIS (A), Number of Segments: 2, Number of Blocks: 4)
1) Verify that the MEMRECAM GX-5 is in STOP mode.
2) While in STOP mode, press VIEW/ARM
The memory segment number (SEG) superimposed on the
image shows "A". The AUTO mode settings are displayed.
The frame counter (FRAME) superimposed on the image shows
"04 A". There are 4 blocks displaying the ALL BLOCKS mode
setting.
3) While in VIEW mode, press VIEW/ARM
The frame counter (Frame) displays "01 A". While the images
are overwritten to block 1, it awaits trigger input.
4) While in ARM mode, press TRIG
REC mode.
Recording will end according to the set trigger timing.
5) Once recording to the appropriate block (B1) has been completed, it switches to the next block (B2) and
automatically switches from REC mode to ARM mode.
6) Repeat recording in 4)～5), and once recording to all of the blocks in the appropriate memory segment
(SEGMENT1) has been completed, it switches to the next memory segment (SEGMENT2) and
automatically switches from REC mode to ARM mode.
7) If the recording operation from 6) is repeated and recording to all of the memory segments has been
completed, it switches from REC mode to STOP mode. The memory segment does not automatically
switch after the final memory segment (SEGMENT2) recorded.
8) Memory protection applies to memory segments where the recording has been completed so it does
not switch to ARM mode. If you want to record again, either change the settings to a recording method
other than AUTO mode, or erase the memory segment.
※ Press STOP
stop recording. Depending on the camera mode when STOP
saved before recording is stopped will vary.
● If STOP
If the custom setting for the trigger timing is +100%, recording stops when the same number of
frames is saved.
● If STOP
Recording stops after saving from the frame where recording was started to the frame at the instant
STOP was pressed
(00200)
switching of the Camera mode with the JPAD3 operation
automatic switching of the Camera mode, Segment and Block
ARM REC ARM REC
B3
SEGMENT 1
even when recording to the appropriate memory segment has not been completed to
is pressed during ARM mode
is pressed during REC mode
ARM REC
B4 B1
on the JPAD3 to switch to VIEW mode.
on the JPAD3 to switch to ARM mode.
on the JPAD3 or use the external trigger for input to switch to
3-27
ARM REC ARM REC
B2 B3
SEGMENT 2
is pressed, the number of frames
STOP
VIEW
Memory
Protected
ARM REC
B4