Troubleshooting - Stealth Bomber Owner's Manual

TROUBLESHOOTING

In the event that your Stealth Bike will not go, or runs roughly, the following chart may help to quickly fix the problem.
In other instances you will require the assistance of your dealer. If in any doubt, contact your dealer.
Problem
Bike is not running smoothly
or there is a strange noise
Bike is switched on but won't
run
Screen not turning on
Stealth Electric Bikes Owner's Manual
Cause
Connectors have dislodged or have
water ingress/corrosion
Possible hall sensor malfunction
Possible controller malfunction
Loose/corroded connectors or wires
Water in connectors
Possible damaged hall sensor
BMS needs to be reset
Possible problem with key
switch/connectors
Possible problem with screen
connector
Battery not charged
Action
Visually inspect all wires to ensure that
there are no breakages or wear
Check all connectors beneath battery pack.
Ensure they are dry. Use an air gun to expel
water if moisture is found
Check large 3 pin connector to motor
Check small 5 pin connector to motor
Refer to dealer if damage is found
Refer to dealer
Refer to dealer
Visually inspect all wires to ensure that
there are no breakages or wear
Check all connectors beneath battery pack
Check large 3 pin connector to motor
Check small 5 pin connector to motor
Refer to dealer
Follow BMS reset procedure found below
Inspect key switch and connectors and
check for continuity
Inspect screen and connectors
Plug charger into bike
25