Stealth Bomber Owner's Manual page 12

CAUTION:
The battery charger for your Stealth Bike can operate on dual voltages (120V/240V). Before
charging the bike for the first time, make sure that the red switch on the back of the charger is set to
the correct mains power supply voltage for your region.
i. Ensure the bike is switched off and the charge port is clean and dry.
ii. Connect the charger to the wall socket. A red and a green light should illuminate.
iii. Now connect the charge plug to the charge socket located on the front LHS of the bike. The charger should then
display 2 red lights, and the charge cycle should commence.
iv. The complete charge period should last approximately 2-2.5 hours. At the end of the charge cycle the charger will
illuminate 1 red and 1 green light. This indicates that the battery is fully charged and the charger can be
disconnected.
Ensure bike is turned off
NOTE: It is not unusual to see the red and green lights cycle on and off toward the end of the charge period. This indicates
that the battery is balancing and it is best to wait until the cycling has stopped to get the best from your battery pack.
Stealth Electric Bikes Owner's Manual
Ensure charge port is clean
and dry
Two red lights are displayed
when battery is charging. You
should also be able to hear
the fan running
Connect charger to charge
port
A red and green light is
displayed when charger is
disconnected from bike or
battery is fully charged
12