Adjusting Your Bike; Tyres; Chain - Stealth Bomber Owner's Manual

ADJUSTING YOUR BIKE

TYRES

Check tyre pressures and ensure that the pressure range is between 25psi and 40psi.

CHAIN

The chain should be checked, adjusted and lubricated as shown on the Maintenance Schedule to ensure proper
operation and prevent excessive wear. If the chain becomes badly worn or is poorly adjusted (i.e., if it is too loose or
too taught), it could damage the drive train or transmission of the bike.
Chain tension should be just enough to remove any slack from the chain but loose enough that pushing moderately on
the middle section of the chain does not cause deflection of more than 10mm (shown below).
chain needs replacing.
Loosen adjuster nuts
To adjust chain tension:
1. Loosen axle nut on each side of rear wheel.
2. Tighten/loosen 10mm on axle adjuster nuts (circled above) to achieve desired tension.
3. Ensure rear wheel is in-line with bike.
4. Tighten axle nuts.
The chain may be lubricated using any good quality silicone chain lube.
Stealth Electric Bikes Owner's Manual
Deflection should be
no more than 10mm
19
.
Refer to your dealer if