Operation - Makita 4100NH2 Instruction Manual

009556
CAUTION:
After adjusting the depth of cut, always tighten the
•
clamping nut securely.
Sighting
B
A
009559
For straight cuts, align A with your cutting line on the
workpiece. For 45° bevel cuts, align B with it.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
1
014268
For tool with lock button
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop. For continuous operation, pull
the switch trigger, push in the lock button and then
release the switch trigger. To stop the tool from the
locked position, pull the trigger fully, then release it.
For tool with lock-off button
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, depress the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
1. Clamping nut
2. Base
1
2
1. Switch trigger
2. Lock button /
Lock-off button
2
CAUTION:
Do not pull the switch trigger hard without pressing in
•
the lock-off button. This can cause switch breakage.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing diamond wheel
1
2
009563
Hold the outer flange with the wrench and loosen the
hex bolt clockwise with the hex wrench. Then remove
the hex bolt, outer flange and diamond wheel.
To install the wheel, follow the removal procedure in
reverse. Always install the wheel so that the arrow on
the wheel points in the same direction as the arrow on
the blade case.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
1
2
009564
CAUTION:
Use only the Makita wrench and hex wrench to
•
install or remove the wheel.

OPERATION

009561
6
1. Outer flange
2. Wrench
3. Hex wrench
3
1. Inner flange
2. Diamond wheel
3. Outer flange
3
4. Hex bolt
4