Checking Procedures After Reassembly; How To Do In Troubles - Robin EC03ER Service Manual

(7) Reassemble parts in reverse order of
disassembly. (See Fig. 23.)
Screw
* * * * *
1 pce.
TIGHTENING TORQUE
295
-
390
kgf cm
30
-
40 N * c m
30
-
35 IN-LB
0
This ,is the end of the disassembly and
reassembly procedures.
Test the reassembled recoil starter by the
following checking procedures in the next
section.
Fig. 27
4- 3 CHECKING PROCEDURES AFTER REASSEMBLY
(1) Pull starting knob 2 or 3 times, and pull out starter rope a little.
a) If starting knob is felt heavy to pull or cannot be pulled, check whether all the parts are
b)
If ratchet does not function, check whether spring is hooked properly.
a) If starter rope remains left in reel or starter rope does not return at all, immoderate strain
is imposed on the spring. So rewind starter rope
1
or
2
times as per instruction in
Fig. 22.
b)
I f '
return power of starter rope is weak or starter rope cannot be fully rewind, inject a few
drops
of
mobile oil to the frictional portions. If it does not recover yet, wind the rope 1
or 2 times.
(In this
case, refer to the instructions explained in paragraph a) above and confirm whether
or not immoderate strain is imposed on spring.)
c ) If a sound is heard that spring is falling off, and starter rope does not return, reassemble
once again from the biginning.
installed correctly.
(2) Pull starting knob, and pull out starter rope all the way long.
(3) Push the washer
a) I f washer is loose, retighten the bolts.
4-4 HOW TO DO IN TROUBLES
(1) IN
CASE THE SPRING JUMPS
OUT
AT DISASSEMBLING.
Remove starter knob from rope.
0
Remove reel from starter case.
0
Hook outer end
of spring t o the reel. (See Fig. 26.)
0
Wind spring into the reel.
0
After winding 3 or 4 turns, tape spring
to the reel to prevent the spring from jumping
out.
r
Prass outer end of spring by a thumb or spiral spring jumps out from reel.
-
23
-