Vivotek SD8363E-M User Manual page 7

Ethernet 10/100 RJ45 Plug
General I/O Terminal Block
Spring Contacts for Dehumidifier
Status LED
Item LED status
1 Steady red
Red LED off
2 Steady red & Green blinking every 1 sec.
Steady red & Green LED off
3 Red blinking every 0.15 sec. & Green blinking
every 1 sec.
4 Red blinking every 0.15 sec. & Green blinking
every 0.15 sec.
Hardware Reset
The reset button is used to reset the system or to restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the system problems remain
after reset, restore the factory settings and install again.
Reset: Press and release the recessed reset button with a paper clip or thin object. Wait for the
Network Camera to reboot.
Restore: Press and hold the recessed reset button for a while to restore. Note that all settings
will be restored to factory default.
SD/SDHC/SDXC Card Capacity
This network camera is compliant with SD/SDHC/SDXC 32GB, 64GB, and other preceding
standard SD cards.
Interface Section
AC24V
DI GND
AC24V
DI4
Reserved
DI3
MIC IN DI2
Line OUT DI1
Audio GND DO2
RS485-
DO1
RS485+ DO+(12V)
Description
Power on and system booting
Power off
Network normal (heartbeat)
Network failed
Upgrading firmware
Restoring default
VIVOTEK
User's Manual - 7