Vivotek SD8363E-M User Manual page 10

VIVOTEK
2. Connecting Power and I/O Wires
If you need to connect I/O wires and 24V power, disassemble the top section of the camera. It is highly
recommended to complete the following before you can mount the speed dome camera at the installation
site:
Skip this section and move to Section 3-3 if you connect the Ethernet cable only.
2-1. Cabling through the Waterproof Connectors
Components of the Waterproof Connector
Screw Nut (A)
Seal (B)
10 - User's Manual
1-3 Connect with the mount bracket
Cabling through the dome cap and waterproof
1-1
connectors
Plan the wire length and complete cabling to the
1-2
Interface Section
Seals (C)
Housing (D)
Sealing Nut (E)
• Wire range: 13~16AWG (1.2~1.8mm)
• A socket wrench for the M20 hex nut is required.