Advertisement
POWER COII]IECTTOIIS
Be certain all associated equipment is turned off before plugging in the
preamp. Insert the power cord into the AC LINE INPUT on the back panel
and then connect it to an appropriate power source. Then you may turn
on vour other comoonents.
The preamplifier is designed to be left on continually. By leaving the
electronics on, they stay warm and are always in their optimum operating
state and readv for immediate use. However. there is a power switch
provided on the rear panel for occasions when you would like to turn
your preamplifier off (i.e. you go away on vacation or there is a lightning
storm). The preamplifier uses just a few watts of power so power
consumption is not an issue. All indicator lights are light emitting diodes
(LEDs), including the digital display, so they will never burn out or need
reolacement.
ETECTRTCAI PROTECTTO]I
Although not essential, it is a good idea to use a surge protector to
prevent damage to your expensive equipment in the event of an electrical
storm or other causes of abnormally high voltage. These are inexpensive
and can be obtained from anv hardware store. You do not need to use an
expensive line conditioner, but if you do, these normally will have surge
protection built-in so you do not need to use additional surge protection.
The AC line voltage and line fuse of the preamplifier are preset at the
factory for your location. lf it is necessary to change these settings,
contact the factory for instructions.
Advertisement
