Advertisement
Disassembly method
Removing the battery cover (See Figure 1)
(1) Open the battery cover.
(2) Pull out the battery cover as a small flat screwdriver lifts
hook of the battery terminal.
(3) A hook is locked if it inserts as it is when attaching a battery
cover.
Removing the USB port cover (See Figure 2 to Figure 5)
(1) A dial is united with a standard side (Illustration side of a
mountain)[Fig.2]
(2) Remove the two screws A attaching the front cover.[Fig.2]
(3) Remove the one screw B attaching the rear cover.[Fig.2]
(4) Remove the two screws C attaching the rear cover[Fig.3]
(5) While pressing a part a (then hook c is removed. See
fig.6.), lift the front cover right up and remove it.[Fig.4]
(6) A USB port cover is drawn out upwards.[Fig.5]
* When attaching a front cover, it attaches pushing Hook c.
[Fig.6]
* When you attach a front cover, please check that the position
of a dial is on the standard side (Illustration side of a moun-
tain) correctly.
*Keep in mind that the kinds of screw differ.
Screw A --- Short
Screw B --- It is a long and fine-pitch screw
Screw C --- It is a long and coarse -pitch screw
Hook c
Rear cover
!
Since the high voltage for flashes
is charged, this capacitor warns
against the ability touching a hand.
Capacitor
USB Port cover
Fig.5
Front cover
Fig.6
Battery cover
Fig.1
Front cover
Dial
A
Rear cover
Fig.2
C
Front cover
C
Rear cover
Fig.3
Front cover
a a
Push
Push
Fig.4
Hook
B
(No.XC004)1-3
Advertisement
