Diagrams - Sony HCD-DZ500F Service Manual

HCD-DZ500F
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Schematic Diagrams.
Note:
• All capacitors are in µF unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and
specified.
• f : internal component.
• C : panel designation.
Note: The components identified by mark 0 or dotted
line with mark 0 are critical for safety.
Replace only with part number specified.
IC103 is a written in and settled EEPROM. Supply with
a single article has not been carried out. In case you
exchange by DMB10 board (A-1108-644-A), please
put on IC103 currently used with the model again.
• A : B+ Line.
• B : B– Line.
• Voltages and waveforms are dc with respect to ground un-
der no-signal (detuned) conditions.
• Voltages and waveforms are dc with respect to ground in
service mode.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
no mark : DVD STOP
• Voltages are taken with VOM (Input impedance 10 MΩ).
• Circled numbers refer to waveforms.
• Signal path.
F
: AUDIO
J
: CD PLAY
c
: DVD PLAY
I
: SACD PLAY
d
: TUNER
L
: VIDEO
E
: Y
a
: CHROMA
r
: COMPONENT VIDEO
q
: R, G, B
f
: AUDIO IN (SAT)
h
: AUDIO IN
• Abbreviation
RU : Russian model.
20
SECTION 5

DIAGRAMS

1 / W or less unless otherwise
4
For Printed Wiring Boards.
Note:
• X : parts extracted from the component side.
• a : Through hole.
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from
(SIDE A) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(SIDE B) the parts face are indicated.
• Indication of transistor.
B C E
These are omitted
C
Q These are omitted.
B E