Modules tab
This tab consists of blocks which are Key wedge, Setting utilities, Test utilities and Com port power setting.
You can enable Key wedge feature, test optional modules and set power status for Com ports.
Item
1
Check the box and tap the Apply button to enable MSR/ 1D BCR/ 2D BCR key wedge
mode. Key wedge mode is a software interface lets you to convert MSR/ 1D BCR/ 2D BCR
input data to keystrokes.
2
These button are used to enter the moulde test utilities. You can use these utilities to test the
installed modules.
3
Select the COM port power setting for COM6 (MSR moudle) and COM7 (RFID/ BCR
moudle), and then tap the Apply button to confirm.
Description
1
2
3
31