Plugging In Your Unit; Starting Your Service - ADT CS-6000 How To Use Manual

2

Plugging in your unit.

• Using the phone cord provided, plug
one end into the back of the BASE
UNIT (Figure A) in the jack marked
"THIS PLUG TO WALL OUTLET" and
the other end into your wall jack. (See
Figure D)
• If you normally use the wall jack for a
phone or other device, plug that device
into the back of the unit in the jack
marked "PLUG PHONE OR OTHER
DEVICE HERE."
• Next, plug the power transformer into
the power outlet.
3

Starting your service.

You MUST contact the ADT Activation Help
Desk at 1.800.498. 8512 to begin using your
Companion Service unit.
Our Help Desk Coordinator will place your unit in service and make it
"active" in our Customer Monitoring Center.
• The Help Desk Coordinator will verify your account information and
test your communication link to our Customer Monitoring Center.
This process takes just a few minutes.
Your unit should now be connected to our Customer Monitoring
Center and ready to use.
(Figure D)
BACK OF BASE UNIT