Advertisement
Switch Housing
Mounting Plate
Fig. 13
Pre-installed Blade
to Motor Screws
Step 7 Fan Blade Assembly Installation
Remove the large screws in the face of the
motor. Discard any rubber blocks attached to
these screws. The rubber blocks are installed at
the factory to stabilize the motor during ship-
ment.
Select the correct mounting pattern and attach
each blade to the motor face using the two
screws attached to the blade arm (see figure 13).
Take care not to bend the blade arms during
installation. This will cause your fan to wobble
while running.
Blade
Try mounting the blades on opposing sides of the
motor face, This will help keep the fan more
level during blade installation.
9
Advertisement
