Advertisement
Step 3 Hanging the Fan Body
Notice the half ball on the end of the support
rod is grooved down one side (see figure 6).
This Keyway fits over the small keyway pin
on the inside of the mounting bracket and
keeps the ceiling fan from spinning on the
mounting bracket.
Using your step ladder, lift the fan and place
the half ball in the center of the mounting
bracket with the keyway pin inserted into the
keyway on the ball. Turn the fan left and
right slightly to make sure it is seated on the
bracket with the keyway pin in the keyway
(see figure 7).
Trim the lead wires, leaving about six inches
of each wire extending from the support rod
(see figure 8).
6
Ball Hanger
Support Rod
Ball Hanger
Support Rod
Ball Hanger
Mounting Bracket
Keyway Pin
Fig. 6
Mounting
Bracket
Keyway Pin
Fig. 7
Ground Wire
Support Rod
Fig. 8
Advertisement
