Advertisement
Fig. 4
Ceiling Canopy
Threaded End Of
Support Rod
Support Rod
Set Screws
Fig. 5
If you are using an extended support rod, (longer
than the one supplied with your fan) remove the
half ball from the small support rod that came
with the fan and put it on the extended support
rod. Make sure to retighten the set screw and
insert the safety screw.
Step 2 Attach the support assembly
Loosen the set screws (2) in the support rod
coupler located on the top center of the motor
housing (see figure 5) until the inside channel is
clear.
Remove and save the safety screw from the
coupler.
Place the ceiling canopy face down (small end)
over the support rod coupler on the motor hous-
ing.
Support Rod
Coupler
Slide canopy onto support rod.
Safety Screw
Feed the electrical wires from the fan housing
through the support rod.
Thread the support rod into the support rod cou-
pler until the safety screw can be inserted
through the hole in both the rod and coupler.
Insert the safety screw through the hole in the
support rod coupler and support rod then tight-
en firmly.
Insert the set screw in the coupler and tighten
firmly.
Pull the electric wires in the
junction box down through
the mounting bracket and
then bend them up and back
out of the way.
This will
leave the mounting bracket
open and ready to receive the
ceiling fan (see figure 4).
5
Advertisement
