Hyundai WS 1166 Instruction Manual page 22

Note:
1) All Setting mode will automatically exit in 15 seconds without any adjustment.
2) For Time Zone: The Time zone is used for the countries where can receive the DCF time
signal but the time zone is different from the German time. When the country time is faster
than the German time for 1 hour, the zone should be set to +1. Then the clock will
automatically set 1 hour faster from the signal time received.
If you receive no RC-DCF frequency signal, the time zone should be set to 0.
4.3 Daily Alarm Setting:
• Press " MODE" button (B1) to select to view
Time  Alarm Time („AL" shown on the display)
• When viewing the Alarm Time, hold "MODE" button (B1) for 3 seconds to enter Alarm Time
setting. Press "▲" (B6) or "▼" (B4) button to adjust the alarm time. Press "MODE" button (B1)
to confirm the setting.
4.4 Snooze Alarm Function:
• Press "ALARM" button (B3) to activate the alarm function. "
• When alarm alerts, press any button to stop the alarm. Otherwise, the alarm signal sounds for
about 2 minutes, then stops automatically.
• Press "SNOOZE / LIGHT "(B2) to activate the snooze function. "
• Press "SNOOZE / LIGHT" (B2) button when alarm alerts. The alarm snoozes for around
4 minutes, then it alerts again. The snooze function can be enabled for maximum 8 times.
" " flashes on the LCD during the snooze time.
• Except "SNOOZE" button, press any button to stop the snooze alarm, or press "ALARM"
button (B2) to deactivate snooze alarm function. "
4.5 12/24 Hour Display mode:
Press "12/24" button (B11) to select 12 or 24 hours mode.
5. THERMOMETER
• Press "°C / °F" (B4) button to select Temperature in Celsius mode / Fahrenheit mode.
• If the temperature is out of the measurable range, LL.L (beyond the minimum temperature)
or HH.H (beyond the maximum temperature) will be shown on the LCD.
6. BACKLIGHT
Press "SNOOZE / LIGHT" button (B2), back light states for 5 seconds.
7. PRECAUTIONS
• The clock loses its time information when the battery is removed.
• Do not expose it to direct sunlight, heavy heat, cold, high humidity or wet areas
• Never clean the device using abrasive or corrosive materials or products. Abrasive cleaning
agents may scratch plastic parts and corrode electronic circuits.
we reserve the right to change technical specifications.
" appears on the display.
" & " " disappear from the display.
EN - 22
" appears on the display.