Table of Contents
Advertisement
[MOTION SETUP]
detects motion continuosly, the DVR keeps recording through out the event, and the duration after the last motion
event. For example, the duration is set to 10 seconds and the motion last for 3 minutes. The DVR records for 3
minutes and 10 seconds.
5.[NUMBER OF CELLS TO DETECT]
It will only be triggered when the cells in motion are MORE THAN the number the user has set.So the smaller
the number is, the more sensitive the detection is.
[MOTION MASK SETUP]
2.ALL ON: Change the mode to ALL ON and press ENTER to activate the motion detection in the whole window.
3. ALL OFF: Change the mode to ALL OFF and press ENTER to deactivate the motion detection in the whole
window.
4.BLOCK ON: Block an area to activate the motion detection in the desired area. Move the cursor to a corner cell of
the desired area and press ENTER to mark the starting cell of the block. Then, move the cursor to the cell at the
diagonal end of the desired area and press ENTER to finish marking the block. When the window is at the ALL OFF
mode, you can activate the motion detection in the block.
5.BLOCK OFF: Block an area to deactivate the motion detection in the desired area. The setup steps are the same
as BLOCK ON. If the window is at the ALL ON mode, you can deactivate the motion detection in the block you
make.
CELL [1]
Channel
Edit mode
JPEG2000 Stand alone DVR User Guide
1.[CHANNEL]
Select a channel for the setup.
2.[SENSITIVITY GRADE]
Adjust motion detection sensitivity. 1 (LOW)~4 (VERY HIGH)
3.[MOTION DISPLAY TYPE]
Setup the display type that marks the motion area.
BOX- shows block / CELL- shows green lattice
4.[RECORD DURATION]
The DVR record for duration from the time motion is detected. If the DVR
Users can set up which area to detect motion and which not to detect. The area
that is marked not to detect motion is Grey.
Press the number button to select the channel.
Set motion detection area. Use the Direction buttons to move the cursor and
press [ENTER] to mark the area.
Press [Mode] to change the editing mode. The editing modes are as below:
1.Cell: Move to the desired location and press [ENTER] to activiate or
deactiviate the motion detection in the marked area cell by cell.
Note:Please go to [RECORD SETUP] > [SCHEDULE RECORD] and change
the record mode to MOTION to activiate the MOTION settings.
- 30 -
Advertisement
Table of Contents
