Vinotemp VT-WINEDISP2 Owner's Manual page 8

Hide thumbs Also See for VT-WINEDISP2:

Table of Contents

Attaching and Removing Wine Bottles

Unscrew lower part of bottle fix nut and place it on the neck of desired wine bottle.

Slide bottle upward, with gas and wine tube inside the bottle.

Fit bottle mouth into silicon plug. If bottle mouth is larger, lift upper part of bottle fix

nut to free silicon plug completely and ease bottle mouth into the silicon plug first.

Tighten lower part of bottle fix nut to the upper part.

Press the dispensing button to allow wine out and check to see if gas leakage will

occur. (Reconnect tighter if needed so gas does not escape.)

Place wine fully in refrigerated cabinet and close door.

Once the wine dispenser is positioned and plugged in, turn the power on.

Dispensing Wine

The wine dispenser features two sets of two dispensing buttons, each positioned directly above

its corresponding wine bottle spout. The two dispensing button options are:

Press and hold the

into your glass. Wine will continue to be dispensed until the button is released.

Press the

dispense 1oz, twice to dispense 2oz, and so forth.

Setting the Temperature

The temperature display will show the current temperature inside the unit. To set a temperature,

press and hold the

flash. Once the temperature display starts to flash, use the

desired temperature.

For wine to stay fresh up to 45 days, bottles must be closed and unit preservation system must

be properly sealed to prevent deterioration. Keep wine at proper temperature in unit.

LED Light

The LED light can be switched on or off by pressing the

button over the desired spout to begin dispensing wine

button to dispense wine in 1oz increments. Press it once to

button till the display shows "H1" and the displayed temperature starts to

W W W . V I N O T E M P . C O M

buttons to select your

button.

Table of Contents