Table of Contents
Advertisement
Problem
The engine being
jumpstarted will not start.
The jump-start clamps
measure zero volts.
The compressor runs, but
won't infl ate.
The compressor runs
slowly
Possible Cause
®
Duracell
Powerpack
battery is not fully
charged.
The engine condition is
poor.
The engine start capacity
exceeds the Duracell
Powerpack jump-start
capability.
Jump-start power switch
is OFF.
®
Duracell
Powerpack
battery needs to be
recharged.
The valve connector may
not be securely placed on
the valve stem.
The item being infl ated
may have a leak.
The compressor may
have overheated from
excessive use.
Battery voltage is too low.
32
Solution
Recharge the Duracell
Powerpack battery.
Have the engine serviced.
Use a higher power Duracell
®
Powerpack.
Turn the jump-start power
switch ON.
Recharge the battery.
Make sure the valve connector
is securely placed on the valve
stem before closing the thumb
latch.
Make sure the item being
infl ated doesn't have a leak.
Check the compressor hose for
any breaks or leaks.
Turn off the compressor and let
it cool down.
Check the condition of the
internal battery. The battery
may need to be recharged or
replaced.
®
®
Advertisement
Table of Contents
