Advertisement
. ,
.
.
. . . . . .
. I
. I . .
Length of Cord (Feet)
25
50
100
AWG Size of Cord
18
18
18
ACCESSORIES
CAUTION:
These accessories or attachments are recommended for use with your Makita tool specified
in this
manual. The use of any other accessories or attachments might present a risk
of
injury
to
persons.
The accessories or attachments should be used only in the proper and intended manner.
150
16
-
Battery cartridge
7000
e
Battery cartridge 7033
.
Shear blade assembly
,
High capacity battery charger
Model
DC1411
-
Battery cover
-
Blade cover
I
IMPORTANT SAFETY INSTRUCTIONS
FOR CHARGER &
BATTERY CARTRIDGE
1 .
2 .
3.
4.
5.
6.
7.
8.
9.
1 0 .
1 1 .
12.
SAVE THESE INSTRUCTIONS
-
This manual
contains important safety and operating instructions for battery charger.
Before using battery charger, read all instructions and cautionary markings on
( 1 )
battery charger,
( 2 )
battery, and (3) product using battery.
CAUTION
-
To reduce risk of injury, charge only MAKITA rechargeable batteries
marked on the charger label. Other types of batteries may burst causing personal
injury and damage.
Do not expose charger to rain or snow.
Use of an attachment not recommended or sold by the battery charger manufacturer
may result in a risk of fire, electric shock, or injury t o persons.
To reduce
risk of
damage t o electric plug and cord, pull by plug rather than cord when
disconnecting charger.
Make sure cord is located so that it will not be stepped on, tripped over, or otherwise
subjected to damage or stress.
An extension cord should not b e used unless absolutely necessary. Use of improper
extension cord could result in a risk of fire and electric shock. If extension cord must
be used, make sure:
Do not operate charger with damaged cord o r plug
-
replace them immediately.
D o not operate charger if it has received a sharp blow, been dropped, or otherwise
damaged in any way; take it t o a qualified serviceman.
D o not disassemble charger
or battery cartridge; take it t o a qualified serviceman
when service or repair is required. Incorrect reassembly may result
in
a risk of
elec-
tric shock
or fire.
To reduce risk of electric shock, unplug charger from outlet before attempting any
maintenance or cleaning. Turning off controls will not reduce this risk.
1 3 . If operating time has become excessively shorter, stop operating immediately. It may
result in
a risk
of overheating, possible burns and even an explosion.
14. If electrolyte g e t s into your eyes, rinse them out with clear water and seek medical
attention right away. It may result in
loss of
your eyesight.
12
5
Advertisement
