Advertisement
V.
Rewinding-whether
by hand
or
using the motor-must always be
carried out with the lens-holder in the "closed" position.
Manual rewind
1. Screw the rewinding handle
into
the upper spool arm.
2. Take hold of the free end of the film,
and fasten it to the core of the upper
spool (now empty), following the
path shown.
3. Rewind the film
by turning the
handle in the direction shown by
the arrow.
Motor rewind
1. Fix the spring belt into place as
shown (Fig. 20). Take hold of the
free end of the film and fasten it to
the core of the upper spool, follow-
ing the path shown.
2. Set knob 23 nearly to minimum speed.
3. Set the operating switch on posi-
tion b.
4. Engage the rewinding mechanism,
by pressing on the grooved rewind-
ing knob 13.
5. When all the film has been wound
back, stop the projector by pushing
on the operating switch.
IV
V
Unloading
To unload the projector after showing part of a
film, proceed as follows
Open the gate by pulling the lens-holder for-
wards.
Free the film from the sprockets by pressing on
part
g
of the sprocket guides.
Rewind the film by hand or using the motor, as
described above (see Fig. 19 and 20).
9
VI
VII
Advertisement
