Advertisement
II. Setting up the projector
The operati ng switch
20 shou Id
be on
"Stop."
Open up hinged panel 21, and check that
a projection lam p is fitted and in the correct
position. To do the latter, turn the projection
lamp in the direction shown by the arrow.
The flanges on the lamp base 22 should
touch the stops in the lamp-holder socket.
The projector can either be stood on a
table or on its carrying case, or it can be
set up on the special Paillard Bolex tripod
stand for cine projectors.
Centering
the projection image
on the screen
a) Projector set up on table or
carryi ng case :
The projection beam may be aimed in a
horizontal direction, or it may be pointed
upwards or
downwards~
Connect the pro-
jector to the power supply, and set the
operating switch to position c (motor run-
ning and projection lamp lit-see general
view).
An image of the aperture in the
gate will appear on the screen. Bring this
image into focus by turning the focussing'
ring 8 on the lens.
Use the speed con-
trol knob 23 to adjust the motor speed so
as to eliminate any trace of flicker on the
screen.
Center up the image of the gate
aperture in the middle of the screen, by
turning knobs 10 and 14.
Reset the operating switch to "Stop."
4
Advertisement
